Every project starts with a sketch with all of your preferences in mind so that you know exactly what your piece will look like and cost before it goes to production. Hannah hand draws your design in 3 views all to spec so you know exactly what your creation will look like before it's made. "To spec" means it is a technical drawing where all measurements are accounted for, i.e. your ring size, any stone sizes, prongs, heights, widths, etc. If you're not sure exactly what you want Hannah will draw a few concept designs for you to consider based on your taste and anything you communicate as being an important factor for your piece in our initial design meeting. Once a piece is drawn we will meet again and go over the designs. Once a design sketch is approved it goes to CAD where it gets built on a computer in 3D. There are typically a few rounds of revisions here and I will walk you through as much or as little of that as you want. Once things are looking good your piece gets cast in either gold or platinum, diamonds/stones are set and the piece gets a final polish. After that the piece is yours to enjoy for a lifetime!
